|
CCNABRAINDUMP5(1) |
| 来源:www.stu88.com 时间:2006-04-01 |
|
WELL I PASSED THIS TEST W IT H A 82% HOPE MY STUDY TIPS AND PRACTICE QUESTIONS HELP!!??
DON CCNA, MCSE
1. If you wanted to find out which commands where available that started with the letter “T”
Help T*
Help T?
T ?
T?
? T
2. type the command to instruct the router to load the IOS from the file named "ios11.2.img" saved on flash?
Load boot flash ios.11.2.img
boot system flash ios11.2.img
load flash ios11.2.img
run flash ios.11.2.img
3. Identify the true statements (2)
Store and forward switching creates variable latency through the switch
Cut through switching creates variables latency through the switch
Store and forward switching works at wire speed
Cut through switching works at wire speed
4. Choose the best answers: Which of the following is the session layer concerned with? (2)
Managing exchanges of data between presentation layer entities
Flow Control and windowing
Establishing, managing and and terminating sessions
Verifying data encoding formats
5. Which ISDN specification series deals with the concepts and terminology surrounding ISDN? (1)
I Series
Q Series
E Series
There is no specific series
6. What does the command “CDP Timer 150” do?
Gives CDP a administrative metric of 150
Configures the rate at which CDP packets are sent
Changes the CDP hold down timer
Sets the CDP hold down timer to 150
7. Which command would set the encrypted secret password to CISCO?
Enable secret cisco encrypt
Enable secret 5 cisco
Enable secret cisco
Enable-secret cisco
Enable password cisco
8. How can you get to user exec mode from the console?
Type “enable”
Type “config terminal”
Press the enter key on the keyboard
Press CTRL-Z key on the keyboard
9. What two occurrences will reset the holddown timer after a triggered update?
HD Timer expires
Infinity is finally defined as some max number
Another update is received indicating net status changed
Another update is received indicating a better metric
The router receives a processing task proportional to the number of links in the internetwork
The router detects fault LSP’s propagating through the internetwork
10. What command displays IPX routing update packets received or transmitted between a router
Sh rip
Disp rip
Sh ipx route
Sh table ipx
Disp ipx route
Disp ipx routing activity
Debug ipx routing activity
Disp ipx interface activity
11. 3 statements describe default encapsulation and LMI type configuration.
IETF encap must be configured unless the connecting routers are both cisco
The LMI type config term options
The default LMI is Cisco
In release 11.3 the LMI type is autosensed
There are only four encapsulations and 3 LMI type options
12. Which 3 commands will display the IPX address on int e0
Sh ipx e0
Sh ipx int
Disp ipx int
Sh int e0 共4页: 1 [2] [3] [4] 
下一篇：CCNA认证考试 (collected from Braindumps)
| |
| [编辑：煮酒论剑] [打印本页] [返回顶部↑] |
|
|
|
|
|
|
|
